All config variables starts with low-case and uses camelCase.
If there is abbreviation at the beginning of the name, the whole
abbreviation will be written in low-case.
If there is abbreviation at the end of the name, the
whole abbreviation will be written in upper-case.
For example, rssURI.
The gain, given the "real sites benchmark" below, is obvious:
```
benchmark old ns/op new ns/op delta
BenchmarkHugo-4 14497594101 13084156335 -9.75%
benchmark old allocs new allocs delta
BenchmarkHugo-4 57404335 48282002 -15.89%
benchmark old bytes new bytes delta
BenchmarkHugo-4 9933505624 9721984424 -2.13%
```
Fixes#2495
Add logging of the errors/warnings which rst2html outputs to its stderr
stream when rendering rst documents. Note that rst2html outputs warnings
and errors to stderr but it also adds them to the generated html. ->
hugo logs everything in stderr as error.
Add / complete adding page context (path to file being rendered) to
anything logged by getRstContent and getAsciidocContent.
See #2570
Also refactor the rendering pages test to accept more than one page source per test run, which wasn't really needed for this issue, but may be in the future.
Closes#2586Fixes#2538
Maps in Viper, Hugo's config backing store, is now properly lower-cased not just on top level, the current situation.
While this is mostly a good thing, as you don't need to know the original casing to look up a value, it will be breaking for people doing direct lookups in the ´Site.Params` map.
We will try to find a solution to this "breakage", but the recommended method to get params values is via the `.Param` methods.
This method is now implemented on `Node`, `Page` and `Site` and is case-insensitive:
* Use `.Param "someKey" ` if you want page param with fall back to site param if not found on page.
* Use `.Site.Param "someKey"` to get a site param
See #2590
This change adds a canonical alias.html template that is used for page
redirects, and passes the page as data to the template under .Page
Fixes#2533Closes#2576
Add DocumentName (path to the file being rendered) to RenderingContext
and use that information to include the path in the error print.
See #2399Closes#2567
Add logging of the errors which asciidoc and asciidoctor output to their
stderr stream when converting asciidoc documents. Note that
asciidoctor's exit code may be SUCCESS even if there are ERROR messages
in its stderr output (tested with Asciidoctor 0.1.4 and 1.5.5).
Therefore log the stderr output whenever it is non-empty.
See #2399
